Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1242/42    IG2 Power Source Circuit

for Preparation Click here


DESCRIPTION

If there is a problem with the master cylinder solenoid power supply circuit, the skid control ECU outputs DTCs and prohibits operation under the fail safe function.
If the voltage supplied to the IG2 terminal is not within the DTC detection threshold due to malfunctions in such as the battery and alternator circuit, this DTC is stored.

DTC No.
DTC Detection Condition
Trouble Area
C1242/42
Vehicle speed is 1.9 mph (3 km/h) or more and voltage of ECU IG2 terminal remains at below 6.5 V for more than 7 seconds.
  1. Battery
  2. IGN fuse
  3. IC regulator
  4. Power source circuit

WIRING DIAGRAM


C132919E01


INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.INSPECT BATTERY
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V



NG
INSPECT CHARGING SYSTEM
OK


2.INSPECT IGN FUSE
  1. Remove the IGN fuse from the driver side J/B.

  1. Check the IGN fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE IGN FUSE
OK


3.INSPECT SKID CONTROL ECU (IG2 TERMINAL)
  1. Install the IGN fuse.



    C124800E03
  1. Disconnect the skid control ECU (S29) connector.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    S29-1 (IG2) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (IG2 CIRCUIT)
OK


4.INSPECT SKID CONTROL ECU (GND TERMINAL)


    C124799E14
  1. Disconnect the skid control ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S28-1 (GND1) - Body ground
    Below 1 Ω
    S28-32 (GND2) - Body ground
    Below 1 Ω
    S29-4 (GND3) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK


5.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is detected (Click here).

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.


    Result:

    Condition
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID