Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1257/57    IG Power Source

for Preparation Click here


DESCRIPTION

The motor relay (semiconductor relay) is built in the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1257/57
Open in motor system circuit (motor input circuit).
Hydraulic brake booster pump motor circuit

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.CHECK PUMP MOTOR OPERATION
  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU (S28) connector.

  1. Depress the brake pedal more than 20 times.

  1. Check pump motor operation.

    OK:
    Pump motor normally operates.



NG
REPLACE MASTER CYLINDER SOLENOID
OK


2.RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Reconnect the skid control ECU (S28) connector.

  1. Turn the ignition switch to the ON position.

  1. Clear the DTC (Click here).

  1. Check if the same DTC is detected (Click here).

    Result:

    Condition
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID