Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Downhill Assist Control Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

The DAC indicator light comes on when the downhill assist control is ready (Click here).

HINT:
Even if the DAC switch is pressed, the DAC indicator light will blink and DAC will not be activated under the following conditions:
  1. Transfer is in 2WD or H4 mode.
  2. ABS system is malfunctioning.
  3. Temperature of the hydraulic brake booster increases and DAC is temporarily canceled.


WIRING DIAGRAM


C132929E04


INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.INSPECT DOWNHILL ASSIST CONTROL INDICATOR LIGHT
  1. Disconnect the skid control ECU connector.

  1. Ground terminal HDCW of the skid control ECU.

  1. Turn the ignition switch to the ON position.

  1. Check that the DAC indicator light comes on.

OK:
DAC indicator light comes on.



OK
REPLACE MASTER CYLINDER SOLENOID
NG


2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)


    I045338E22
  1. Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S28-33 (HDCW) - C11-10
    Below 1 Ω
    S28-33 (HDCW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK


4.INSPECT SKID CONTROL ECU (HDCS TERMINAL)


    C121700E92
  1. Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    S28-44 (HDCS) - Body ground
    DAC switch is pushed in
    Below 1 Ω



OK
REPLACE MASTER CYLINDER SOLENOID
NG


5.INSPECT DOWNHILL ASSIST CONTROL SWITCH


    I044044E04
  1. Disconnect the DAC switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D5-3 - D5-4
    Switch is pushed in
    Below 1 Ω
    D5-3 - D5-4
    Switch is not pushed in
    10 kΩ or higher



NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH
OK


6.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DOWNHILL ASSIST CONTROL SWITCH)


    F052063E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S28-44 (HDCS) - D5-3
    Below 1 Ω
    S28-44 (HDCS) - Body ground
    10 kΩ or higher
    D5-4 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

END