Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > AUTO LSD Indicator Light Remains ON

for Preparation Click here


DESCRIPTION

Engaging the AUTO LSD switch causes the AUTO LSD indicator light to come on when the AUTO LSD is ready (Click here).
The AUTO LSD will not operate even if the AUTO LSD switch is pressed under the following conditions:
  1. TRAC and VSC system is faulty.
  2. Temperature inside the hydraulic brake booster increases and the AUTO LSD is halted.

WIRING DIAGRAM


C132929E03


INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.INSPECT IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED
  1. Check the skid control ECU Connector's connecting condition.

    OK:
    The connector should be securely connected.



NG
CONNECT CONNECTOR TO ECU
OK


2.INSPECT BATTERY
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V



NG
INSPECT CHARGING SYSTEM
OK


3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)


    I045338E23
  1. Disconnect the skid control ECU connector and combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S28-15 (INFR) - C10-17
    Below 1 Ω
    S28-15 (INFR) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK


5.INSPECT SKID CONTROL ECU (CSW TERMINAL)


    C121700E93
  1. Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    S28-43 (CSW) - Body ground
    AUTO LSD switch is not pushed in
    10 kΩ or higher



OK
REPLACE MASTER CYLINDER SOLENOID
NG


6.INSPECT AUTO LSD SWITCH


    I044055E05
  1. Disconnect the AUTO LSD switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A42-3 - A42-4
    Switch is pushed in
    Below 1 Ω
    A42-3 - A42-4
    Switch is not pushed in
    10 kΩ or higher



NG
REPLACE AUTO LSD SWITCH
OK


7.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - AUTO LSD SWITCH)


    I045574E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S28-43 (CSW) - A42-3
    Below 1 Ω
    S28-43 (CSW) - Body ground
    10 kΩ or higher
    A42-4 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

END