Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

DTC    C1741/41    Air Suspension Relay Circuit

for Preparation Click here


DESCRIPTION

When the "UP" side of the height control switch is pressed, a signal is sent from terminal RC of the suspension control ECU to the AIR SUS relay to turn it on.
As a result, the current flows to the AIR SUS relay coil, closing the relay contact, and then the battery positive voltage is applied to the compressor, which causes the compressed air to raise the vehicle height.

DTC No.
DTC Detecting Condition
Trouble Area
C1741/41
Either of the following conditions is detected:
  1. With the AIR SUS relay inactivated, an open signal of the AIR SUS relay is detected for 1 sec. or more.
  2. With the AIR SUS relay activated, a short signal of the AIR SUS relay is detected 8 times successively.
  1. AIR SUS relay
  2. AIR SUS relay circuit
  3. Suspension control ECU

HINT:
Once the ECU stores DTC C1741/41 in the memory, the vehicle height control is suspended until a normal signal is input to the ECU from the AIR SUS relay. However, the control resumes if the ignition switch is turned OFF, and then turned ON again.


WIRING DIAGRAM


F050631E01


INSPECTION PROCEDURE

HINT:
  1. If DTC C1761/61 (ECU malfunction) and/or C1774/74 (power source circuit) is displayed, perform the inspection necessary for DTC C1761/61 (Click here) and/or C1774/74 (Click here) first.
    (If DTC C1761/61 and C1774/74 are output at the same time, perform the inspection necessary for DTC C1774/74 first.)
  2. Start the inspection from step 1 when using the intelligent tester, and start from step 2 when not using the intelligent tester.

1.PERFORM ACTIVE TEST BY INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON, and push the intelligent tester main switch ON.

  1. Select the item "MOTOR RELAY" in the ACTIVE TEST, and operate it with the intelligent tester.

  1. Check the operating sound of the AIR SUS relay when operating it with the intelligent tester.

    OK:
    The operating sound of the AIR SUS relay can be heard.



OK
REPLACE SUSPENSION CONTROL ECU
NG


2.INSPECT AIR SUS RELAY


    C123965E01
  1. Remove the AIR SUS relay from the engine room R/B No. 3.

  1. Measure the resistance between each terminal of the AIR SUS relay.

    Standard resistance:
    Tester connection
    Resistance
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (When battery voltage is applied to terminals 1-2)



NG
REPLACE AIR SUS RELAY
OK


3.CHECK HARNESS AND CONNECTOR (ENGINE ROOM R/B - SUSPENSION CONTROL ECU)
  1. Check for an open or short circuit in the harness and the connector between the AIR SUS relay and the suspension control ECU (Click here).

    OK:
    There is no open or short in the wire harness.

  1. Check for an open circuit in the harness and the connector between the AIR SUS relay and the body ground.

    OK:
    There is no open in the wire harness.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU