Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL STEERING SENSOR


    C088506
  1. Install the steering sensor.



    C088509
  1. Install the steering sensor connector.



2. INSTALL TURN SIGNAL SWITCH ASSEMBLY


    F043318
  1. Install the turn signal switch assembly with the 3 screws.

  1. Connect the 3 connectors to the turn signal switch assembly.



3. INSPECT SPIRAL CABLE SUB-ASSEMBLY
  1. If there are any defects as mentioned below, replace the spiral cable with a new one:

    1. Scratches, cracks, dents or chips on the connector or the spiral cable.



4. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


5. INSTALL SPIRAL CABLE SUB-ASSEMBLY


    H042178
  1. Check that the front wheels are facing straight ahead.

  1. Turn the spiral cable counterclockwise by hand until it becomes harder to turn.

  1. Then rotate the spiral cable clockwise about 2.5 turns to align the mark.

    HINT:
    The spiral cable will rotate about 2.5 turns to either left or right of the center.

  1. Install the spiral cable with the 4 screws.

  1. Connect the 2 connectors to the spiral cable.



6. INSTALL STEERING COLUMN COVER UPR


    F043298
  1. Install the steering column cover upper to the steering column assembly.



7. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel and main shaft assembly.

  1. Install the steering set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. without Steering pad switch:
    Connect the connector.



8. INSTALL HORN BUTTON ASSEMBLY

NOTICE:
  1. Never use airbag parts from another vehicle. When replacing parts, replace with new ones.
  2. Make sure the steering pad is installed to the specified torque.
  3. If the steering pad has been dropped, or there are cracks, dents or other defects in the case or connector, replace the steering pad with a new one.
  4. When installing the steering pad, take care that the wirings do not interfere with other parts and they are not pinched between other parts.



    F043297E01
  1. Connect the horn ground harness to the steering pad.

  1. Connect the 2 airbag connectors.

  1. Install the steering pad after confirming that the circumference groove of "torx" screw is caught on the screw case.

  1. Using a "torx" socket wrench ("Torx" socket wrench (T=30)), torque the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



9. INSTALL STEERING WHEEL COVER LOWER NO. 2


10. INSTALL STEERING WHEEL COVER LOWER NO. 3


11. INSPECT SRS WARNING LIGHT

HINT:
Click here.



12. PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION
Click here


13. CHECK VSC SENSOR SIGNAL
Click here