DTC P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0125 |
|
|
| Related DTCs | P0125: Insufficient engine coolant temperature for closed-loop fuel control |
| Required Sensors / Components (Main) | Thermostat, Cooling system, ECT sensor |
| Required Sensors / Components (Related) | Engine coolant temperature sensor and mass air flow meter |
| Frequency of Operation | MAF meter |
| Duration | 61 seconds: Engine coolant temperature at engine start -8.34°C (17°F) or more 105 seconds: Engine coolant temperature at engine start -19.45 to -8.34°C (-3 to 17°F) 20 minutes: Engine coolant temperature at engine start less than -19.45°C (-3°F) |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | P0100, P0101, P0102, P0103 (MAF meter), P0110, P0112, P0113 (IAT sensor), P0115, P0116, P0117, P0118 (ECT sensor) |
| Fuel cut | OFF |
| Engine | Running |
| Time until "engine coolant temperature" detection temperature reaches feedback start temperature | - |
| When the temperature at the time of engine starting is -8.34°C (17°F) or more | Engine coolant temperature is less than "closed-loop enable temperature" when 61 seconds or more after engine start |
| When the temperature at the time of engine starting is -19.45 to -8.34°C (-3 to 17°F) | Engine coolant temperature is less than "closed-loop enable temperature" when 105 seconds or more after engine start |
| When the temperature at the time of engine starting is -19.45°C (-3°F) or less | Engine coolant temperature is less than "closed-loop enable temperature" when 20 minutes. or more after engine start |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0125) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on.
Turn the tester on.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0125 | A |
| P0125 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT THERMOSTAT |
Remove the thermostat (Click here).
Check the valve opening temperature of the thermostat (Click here).
Reinstall the thermostat (Click here).
|
| ||||
| OK | |
| 3.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal radiator fan operation or any modifications.
|
| ||||
| OK | ||
| ||