Home › BODY › ENGINE HOOD / DOOR › BACK DOOR CLOSER SYSTEM

BACK DOOR CLOSER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Troubleshoot in accordance with the procedures on the following pages.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      3.INSPECT COMMUNICATION MULTIPLEX COMMUNICATION SYSTEM (BEAN)
      1. Check that there is no abnormality in the communication system by inspecting the communication function of the multiplex communication system with the intelligent tester.

        1. (ECU unconnected, communication line abnormal) Without code outputs, proceed to A.

        2. (ECU unconnected, communication line abnormal) With code outputs, proceed to B.



      B.
      GO TO MULTIPLEX COMMUNICATION SECTION
      A


      4.DIAGNOSTIC TROUBLE CODE CHECK
      1. Check the diagnostic trouble code.

        1. Without code outputs, proceed to A.

        2. With code outputs, proceed to B.



      B.
      Go to step 6
      A


      5.PROBLEM SYMPTOMS TABLE
      1. Without applicable symptoms, proceed to A.

      2. With applicable symptoms, proceed to B.



      B.
      Go to step 6
      A


      6.PERFORM TROUBLESHOOTING IN FOLLOWING METHOD, DEPENDING ON MALFUNCTION SYMPTOM
      1. DATA LIST / ACTIVE TEST (Click here)

        1. Inspection with the intelligent tester (DATA LIST)

        2. Inspection with the intelligent tester (ACTIVE TEST)

      2. TERMINALS OF ECU (Click here)


      NEXT


      7.ADJUST, REPAIR OR REPLACE

        NEXT

        END