Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRE
  1. Check the tires for wear and proper inflation pressure.

    Cold tire inflation pressure:
    Except MEXICO:
    Tire size
    Pressure
    P265/60R18 109H
    P265/65R17 110S
    P265/70R16 111S
    220 kPa (2.2 kgf*cm2, 32 psi)
    MEXICO:
    Tire size
    Pressure
    P265/65R17 112S
    P265/70R16 111S
    200 kPa (2.0 kgf*cm2, 29 psi)



    R003031
  1. Using a dial indicator, check the tire runout.

    Tire runout:
    3.0 mm (0.118 in.) or less



2. ROTATE TIRE


    G022181E01
  1. Rotate tires as shown in the illustration.

    HINT:
    See the illustration for where to rotate each tire when you include the spare tire in rotation.



3. INSPECT WHEEL BALANCE


    C080976
  1. Check and adjust the Off-the-car balance.

  1. If necessary, check and adjust the On-the-car balance.

    Imbalance after adjustment:
    265/70R16:
    8 g (0.018 lb) or less
    265/65R17::
    7 g (0.015 lb) or less



4. INSPECT FRONT AXLE HUB


    F042745
  1. Remove the front wheel.

  1. Remove front disc brake caliper (Click here).

  1. Remove the front disc.

  1. Inspect the axle hub backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the bearing.



    F042746
  1. Inspect the axle hub deviation.

    1. Using a dial indicator, check the distortion at the surface of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the deviation exceeds the maximum, replace the bearing.



5. INSPECT REAR AXLE HUB


    F042747
  1. Remove the rear wheel.

  1. Remove the rear disc brake caliper (Click here).

  1. Remove the rear disc.

  1. Inspect the axle shaft backlash.

    1. Using a dial indicator, check the backlash near the center of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the bearing.



    F042748
  1. Inspect the axle shaft deviation.

    1. Using a dial indicator, check the distortion at the surface of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the deviation exceeds the maximum, replace the bearing.