Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › ENGINE REAR OIL SEAL

ENGINE REAR OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE REAR OIL SEAL


    A076329E01
  1. Apply MP grease to a new oil seal lip.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-78010  



2. INSTALL DRIVE PLATE & RING GEAR SUB-ASSEMBLY


    A076326E02
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    P000601E01
  1. Apply adhesive to 2 or 3 threads of the mounting bolt end.

    Adhesive:
    Part No. 08833-00070, THREE BOND 1324 or equivalent



    A076327E02
  1. Install the front spacer, drive plate and rear spacer on the crankshaft.

  1. Using several steps, install and tighten the 8 mounting bolts uniformly in the sequence as shown in the illustration.

    Torque:
    83 N*m{ 846 kgf*cm , 61 ft.*lbf }



3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 2WD)

HINT:
(Click here)



4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 4WD)

HINT:
(Click here)



5. CHECK FOR ENGINE OIL LEAKAGE