Home › ENGINE ยท 2UZ-FE › LUBRICATION › OIL PUMP

OIL PUMP > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY
  1. Remove engine assembly (Click here).



2. REMOVE TIMING BELT
  1. Remove timing belt (Click here).



3. REMOVE CRANKSHAFT TIMING PULLEY


    A072700E01
  1. Using SST, remove the timing pulley.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05010, 09953-05020, 09954-05010)

    NOTICE:
    Do not turn the timing pulley.



4. REMOVE CRANKSHAFT POSITION SENSOR


    B003153
  1. Disconnect the crank position sensor connector.

  1. Remove the bolt and crankshaft position sensor.



5. REMOVE OIL COOLER ASSEMBLY
  1. Disconnect the 2 oil cooler hoses from oil cooler.

  1. Remove the union bolt, plate washer and the oil cooler.

  1. Remove the O-ring from the oil cooler.



6. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY


    A072704E01
  1. Remove the 17 bolts and 2 nuts.

  1. Insert the blade of SST between the oil pan and No. 2 oil pan, and cut off applied sealer. Remove the No. 2 oil pan.

    SST
    09032-00100  

    NOTICE:
    1. Be careful not to damage the contact surface of the oil pan and the No. 2 oil pan.
    2. Be careful not to damage the No. 2 oil pan flange.



7. REMOVE OIL STRAINER SUB-ASSEMBLY


    A072708
  1. Remove the 2 bolts, 2 nuts, oil strainer and gasket.



8. REMOVE OIL PAN BAFFLE PLATE


    A072705
  1. Remove the 2 bolts, 2 nuts and baffle plate.



9. REMOVE OIL PAN SUB-ASSEMBLY


    A072706
  1. Remove the 18 bolts and 2 nuts.



    A072707E01
  1. Using a screwdriver, remove the oil pan by prying between the oil pan and cylinder block in the order shown in the illustration.

    NOTICE:
    1. Be careful not to damage the contact surfaces of the cylinder block or oil pan.



10. REMOVE OIL PUMP ASSEMBLY


    B001044
  1. Remove the 8 bolts.

    HINT:
    Use a 6 mm hexagon wrench for the hexagon head bolt.



    B000951
  1. Using a screwdriver, remove the oil pump by prying the portions between the oil pump and cylinder block.

    NOTICE:
    Be careful not to damage the contact surfaces of the cylinder block and oil pump.

  1. Remove the O-ring from the cylinder block.



11. REMOVE OIL PUMP SEAL


    A054145E01
  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Be careful not to damage the oil pump body. Tape the screwdriver tip.