Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM1440E _51 Engine / Hybrid System _056124 1GR-FE ENGINE CONTROL _0273867 CAMSHAFT POSITION SENSOR A

1GR-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301M 1.INSTALL VVT SENSOR (for Exhaust Side of Bank 2)

a.

Apply a light coat of engine oil to the O-ring of the VVT sensor.

NOTICE:
·

When reusing the sensor, inspect the O-ring.

·

If the O-ring has scratches or cuts, replace the sensor.




b.

Install the VVT sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the sensor connector.


Hide 11301M 2.INSTALL VVT SENSOR (for Intake Side of Bank 2)

a.

Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:
·

When reusing the sensor, inspect the O-ring.

·

If the O-ring has scratches or cuts, replace the sensor.




b.

Install the sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the sensor connector.


Hide 3.INSTALL VVT SENSOR (for Exhaust Side of Bank 1)

a.

Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:
·

When reusing the sensor, inspect the O-ring.

·

If the O-ring has scratches or cuts, replace the sensor.




b.

Install the sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the sensor connector.


Hide 4.INSTALL VVT SENSOR (for Intake Side of Bank 1)

a.

Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:
·

When reusing the sensor, inspect the O-ring.

·

If the O-ring has scratches or cuts, replace the sensor.




b.

Install the sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the sensor connector.