Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › KNOCK SENSOR
RM1440E _51 Engine / Hybrid System _056124 1GR-FE ENGINE CONTROL _0273871 KNOCK SENSOR A

1GR-FE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL KNOCK SENSOR

a.
A388794E01
0.458,0.208 0.771,0.406 0.313,0.198 10 false *A 0.688,0.719 1,0.917 0.313,0.198 10 false *a 2.583,0.854 3.198,1.115 0.615,0.26 10 true 0 to 15° 0.458,3.49 0.771,3.688 0.313,0.198 10 false *B 1.438,0.167 1.75,0.365 0.313,0.198 10 false *b 1.458,3.458 1.771,3.656 0.313,0.198 10 false *b 0.677,4 0.99,4.198 0.313,0.198 10 false *c 2.594,4.156 3.208,4.417 0.615,0.26 10 true 0 to 15°

Install the 2 sensors with the 2 bolts as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

Text in Illustration
*A for Bank 2
*B for Bank 1
*a Engine Rear
*b Top
*c Engine Front


b.

Connect the 2 sensor connectors.


Hide 16332 2.INSTALL NO. 1 WATER OUTLET PIPE

a.

Install the water outlet pipe with the 2 nuts and bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Attach the 3 wire harness clamps.


Hide 11101 3.INSTALL CYLINDER HEAD SUB-ASSEMBLY (for Bank 1)