11302
1.REMOVE TIMING CHAIN COVER SUB-ASSEMBLY
Remove the timing chain cover (See page Engine / Hybrid System>1GR-FE LUBRICATION>OIL PUMP>REMOVAL).
2.SET NO. 1 CYLINDER TO TDC / COMPRESSION
13540
3.REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY
13559
4.REMOVE CHAIN TENSIONER SLIPPER
13506
5.REMOVE CHAIN SUB-ASSEMBLY
13581
6.REMOVE NO. 1 IDLE GEAR SHAFT
13561
7.REMOVE NO. 1 CHAIN VIBRATION DAMPER
13562
8.REMOVE NO. 2 CHAIN VIBRATION DAMPER
13521
9.REMOVE CRANKSHAFT TIMING SPROCKET
10.REMOVE CAMSHAFT TIMING GEARS AND NO. 2 CHAIN (for Bank 1)
13550
11.REMOVE NO. 2 CHAIN TENSIONER ASSEMBLY
12.REMOVE CAMSHAFT BEARING CAP (for Bank 1)
13.REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY RH
14.REMOVE CAMSHAFT TIMING GEARS AND NO. 2 CHAIN (for Bank 2)
13560A
15.REMOVE NO. 3 CHAIN TENSIONER ASSEMBLY
16.REMOVE CAMSHAFT BEARING CAP (for Bank 2)
17.REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY LH
13801
18.REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
13750
19.REMOVE VALVE LASH ADJUSTER ASSEMBLY
13716
20.REMOVE VALVE STEM CAP
11101
21.REMOVE CYLINDER HEAD SUB-ASSEMBLY
Using a 10 mm bi-hexagon wrench, uniformly loosen the 8 cylinder head bolts in the sequence shown in the illustration. Remove the 8 cylinder head bolts and plate washers.
Be careful not to drop washers into the cylinder head sub-assembly.
Cylinder head warpage or cracking could result from removing bolts in an incorrect order.
Arrange the removed parts in the correct order.
Remove the cylinder head sub-assembly.
11102
22.REMOVE CYLINDER HEAD LH
Uniformly loosen and remove the 2 cylinder head set bolts in several steps in the sequence shown in the illustration.
Using a 10 mm bi-hexagon wrench, uniformly loosen the 8 bolts in the sequence shown in the illustration. Remove the 8 cylinder head bolts and plate washers.
Be careful not to drop washers into the cylinder head sub-assembly.
Cylinder head warpage or cracking could result from removing bolts in an incorrect order.
Be sure to keep the removed parts for each installation position separate.
Remove the cylinder head LH.
11115
23.REMOVE CYLINDER HEAD GASKET
11116
24.REMOVE NO. 2 CYLINDER HEAD GASKET