Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › INTAKE MANIFOLD › 2009.08–2013.08
RM1440E _51 Engine / Hybrid System _056128 1GR-FE INTAKE / EXHAUST _0273906 INTAKE MANIFOLD A

1GR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 51405A 4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 11259 6.REMOVE V-BANK COVER

a.
A221454E03
3.073,0.594 2.771,0.594 true 1.125,0.552 1.042,0.552 false 1.042,0.552 0.927,0.813 false 3.104,0.5 3.26,0.646 0.156,0.146 10 false *1 1.146,0.469 1.302,0.615 0.156,0.146 10 false *2

Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

Text in Illustration
*1 Pin
*2 Hook


Hide 17881 7.REMOVE NO. 1 AIR CLEANER HOSE

a.
A221455

Disconnect the ventilation hose and vacuum hose.


b.

Detach the wire harness clamp.


c.

Remove the bolt and loosen the 2 hose clamps.


d.

Remove the No. 1 air cleaner hose.


Hide 17129 8.REMOVE INTAKE AIR SURGE TANK

a.
A221456

Disconnect the throttle body connector.


b.

Disconnect the No. 4 water by-pass hose.


c.

Disconnect the No. 5 water by-pass hose.


d.
A221457

Disconnect the No. 1 fuel vapor feed hose.


e.

Disconnect the No. 1 vacuum switching valve connector.


f.

Disconnect the No. 1 ventilation hose.


g.
A221464

Detach the 2 heater hose clamps.


h.
A221460

Remove the 2 bolts and throttle body bracket.


i.
A225628

Using a clip remover, detach the wire harness clamp.


j.
A221462

Remove the 2 bolts and No. 1 surge tank stay.


k.
A221463

Remove the 2 bolts and No. 2 surge tank stay.


l.
A221465

Remove the 2 nuts, 4 bolts and intake air surge tank.


m.

Remove the gasket.


Hide 23807 9.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

Hide 17111 10.REMOVE INTAKE MANIFOLD

a.
A221466

Remove the 4 nuts, 6 bolts and 2 gaskets.