Home › Engine / Hybrid System › 1GR-FE STARTING › STARTER
RM1440E _51 Engine / Hybrid System _056131 1GR-FE STARTING _0273920 STARTER A

1GR-FE STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 11363A 1.INSTALL FLYWHEEL HOUSING SIDE COVER

Hide 28100 2.INSTALL STARTER ASSEMBLY

a.

Install the starter with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Connect the starter wire with the bolt and nut.

Torque:
for bolt : 8.0 N*m (82 kgf*cm, 71 in.*lbf)
for nut : 9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.

Connect the starter connector.


e.

Connect the ground wire with the bolt.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 28192 3.INSTALL STARTER COVER

a.

Install the starter cover with the 3 bolts.

Torque:
12 N*m (117 kgf*cm, 8 ft.*lbf)


Hide 17105 4.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH

a.

Install the exhaust manifold sub-assembly LH (See page Engine / Hybrid System>1GR-FE INTAKE / EXHAUST>EXHAUST MANIFOLD>INSTALLATION).


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).