Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM1440E _51 Engine / Hybrid System _056132 CRUISE CONTROL _0273923 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

·

When the ECM detects a cruise control switch on signal from the cruise control switch, it sends it to the combination meter through CAN communication. Then the cruise main indicator light turns on.

·

The cruise main indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Select the item below in the Active Test, and then check that the cruise main indicator light illuminates (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp Cruise Cruise main indicator light ON/OFF -

OK:

Indicator light turns on/off.




OK

2.READ VALUE USING INTELLIGENT TESTER

NG

2.READ VALUE USING INTELLIGENT TESTER
a.

Use the Data List to check if the cruise main indicator light is functioning properly (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Cruise Control
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
CCS Indicator M-CPU Cruise main indicator light (Main CPU) / ON or OFF ON: Cruise main indicator light on
OFF: Cruise main indicator light off
-

OK:

On screen, item changes between ON and OFF according to above chart.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG