Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM1440E _51 Engine / Hybrid System _056132 CRUISE CONTROL _0273923 CRUISE CONTROL SYSTEM T

CRUISE CONTROL  CRUISE CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Cruise Control System
Symptom Suspected Area See page
Cruise control switch cannot be turned on (Cruise main indicator in combination meter assembly does not illuminate) Cruise control switch circuit (Click here)
Cruise main indicator light circuit (Click here)
ECM (Click here)
SET not occurring or CANCEL occurring (DTC is not output) Cruise control switch circuit (Click here)
Combination meter assembly (Click here)
ECM (Click here)
Actual vehicle speed deviates above or below set speed Master cylinder solenoid (Skid control ECU) (Click here)
ECM (Click here)
Cruise control not canceled when brake pedal is depressed Stop light switch circuit (Click here)
ECM (Click here)
Cruise control not canceled when shift lever is moved to N Park/neutral position switch assembly (Click here)
ECM (Click here)
Control switch does not operate (-SET, +RES, CANCEL not possible) Cruise control switch circuit (Click here)
ECM (Click here)
SET possible at 40 km/h (25 mph) or less, or CANCEL does not operate Master cylinder solenoid (Skid control ECU) (Click here)
ECM (Click here)
Poor response in ACCEL and RESUME modes Cruise control switch circuit (Click here)
ECM (Click here)
DTC memory is cleared ECM (Click here)
DTC is not output or is output when it should not be TC and CG terminal circuit (Click here)
ECM (Click here)
Cruise main indicator light does not illuminate Cruise control switch circuit (Click here)
Cruise main indicator circuit (Click here)
Combination meter assembly (Click here)
ECM (Click here)
SET indicator does not come on (SET function operates normally) Cruise SET indicator light circuit (Click here)
ECM (Click here)