Home › Drivetrain › A750E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE
RM1440E _52 Drivetrain _056133 A750E AUTOMATIC TRANSMISSION / TRANSAXLE _0273926 TRANSMISSION WIRE A

A750E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  INSTALLATION  


PROCEDURE

Hide 82125J 1.INSTALL TRANSMISSION WIRE

a.

Coat a new O-ring with ATF and install it to the transmission wire connector.


b.

Install the transmission wire with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.
C155913

Connect the transmission wire connector.

HINT:

Push up the lever until the claw of the transmission wire connector makes a connection sound.



Hide 82125J 2.CONNECT TRANSMISSION WIRE

a.
C125285E07
1.156,1.073 1.771,0.604 true 1.052,1.333 0.479,1.219 true 1.146,1.583 1.521,1.375 true 1.083,0.854 0.781,0.74 true 0.635,0.625 0.792,0.802 0.156,0.177 10 true A 1.563,1.26 1.719,1.417 0.156,0.156 10 true B 0.271,1.125 0.427,1.281 0.156,0.156 10 true *2 1.792,0.49 1.99,0.667 0.198,0.177 10 true *1

Connect the 7 connectors to the solenoid valves.


b.

Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

Torque:
for bolt A : 10 N*m (102 kgf*cm, 7 ft.*lbf)
for bolt B : 11 N*m (112 kgf*cm, 8 ft.*lbf)

Text in Illustration
*1 Orange
*2 Blue

HINT:

Each bolt length is indicated below.

12 mm (0.472 in.) for bolt A


36 mm (1.41 in.) for bolt B


Hide 35330 3.INSTALL VALVE BODY OIL STRAINER ASSEMBLY

a.

Coat a new O-ring with ATF and install it to the oil strainer.


b.

Install the oil strainer with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 35106 4.INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

NOTICE:

Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.


a.

Install a new gasket and the oil pan with the 20 bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


Hide 5.ADD AUTOMATIC TRANSMISSION FLUID