A750E AUTOMATIC TRANSMISSION / TRANSAXLE
AUTOMATIC TRANSMISSION SYSTEM
- PRECAUTION2009.08–2015.08from 2015.08
- DEFINITION OF TERMS
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- ROAD TEST
- MECHANICAL SYSTEM TESTS
- HYDRAULIC TEST
- MANUAL SHIFTING TEST
- INITIALIZATION2009.08–2015.08from 2015.08
- MONITOR DRIVE PATTERN2009.08–2015.08from 2015.08
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECM
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- CHECK MODE PROCEDURE
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST2009.08–2015.08from 2015.08
- DIAGNOSTIC TROUBLE CODE CHART
- P0973, P0974
- P0781 Gear required by the ECM does not match the actual gear when driving (1-trip detection logic).
- P0778 The ECM checks for an open or short in the shift solenoid valve SL2 circuit while driving and shifting gears...
- P0776 Gear required by the ECM does not match the actual gear when driving (1-trip detection logic).
- P0771 The gear required by the ECM does not match the actual gear when driving (1-trip detection logic).
- P0756 Gear required by ECM does not match actual gear when driving (1-trip detection logic).
- P0751 Gear required by the ECM does not match the actual gear when driving (1-trip detection logic).
- P0748 The ECM checks for an open or short in the shift solenoid valve SL1 circuit while driving and shifting...
- P0722 All conditions are met 500 times or more continuously (2-trip detection logic): (a) No signal from speed...
- P0717 All conditions are met for 5 sec. or more (1-trip detection logic): (a) Gear change: not performed. (b) Gear...
- P0976, P0977
- P0985, P0986
- P2714 The ECM detects a malfunction of SLT (ON side) according to the difference in speed between the turbine and...
- P2759 Open or short is detected in the shift solenoid valve SLU circuit for 1 sec. or more while driving (1-trip...
- P2716 Open or short is detected in the shift solenoid valve SLT circuit for 1 sec. or more while driving (1-trip...
- P0712, P0713
- P0705 One of the following conditions is met: (A) Any 2 or more of the following signals are ON simultaneously...
- P2742, P2743
- Transmission Control Switch Circuit
- Preparation