Home › Drivetrain › A750E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM1440E _52 Drivetrain _056133 A750E AUTOMATIC TRANSMISSION / TRANSAXLE _0273928 PARK / NEUTRAL POSITION SWITCH A

A750E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Install the switch to the manual valve shaft.


b.
C155872

Temporarily install the bolt.


c.

Install a new lock washer and the nut.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


d.
C212493E02
2.885,0.823 3.031,0.979 0.146,0.156 10 true P 2.49,0.198 2.667,0.354 0.177,0.156 10 true R 1.427,0.094 1.573,0.25 0.146,0.156 10 true N

Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.


e.
U116379E02
1.958,1.594 0.698,1.229 false 1.969,0.927 1.74,0.115 1.74,0.115 1.917,0.115 false 2.906,0.479 2.865,0.531 false 2.771,0.594 2.76,0.615 false 2.885,0.427 2.813,0.542 false 2.833,0.438 2.719,0.594 false 2.771,0.448 2.677,0.583 false 2.74,0.417 2.646,0.573 false 2.708,0.396 2.604,0.552 false 2.583,0.5 2.563,0.542 false 1.938,0.021 2.125,0.188 0.188,0.167 10 false *1 0.479,1.135 0.656,1.313 0.177,0.177 10 false *2

Align the neutral basic line with the switch groove.

Text in Illustration
*1 Neutral Basic Line
*2 Groove


f.

Hold the switch in position and tighten the bolt.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


g.

Using a screwdriver, bend the tabs of the lock washer.


h.

Connect the switch connector.