Home › Drivetrain › A750E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP
RM1440E _52 Drivetrain _056133 A750E AUTOMATIC TRANSMISSION / TRANSAXLE _0273936 OIL PUMP A

A750E AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  REASSEMBLY  


PROCEDURE

Hide 35301A 1.INSTALL FRONT OIL PUMP OIL SEAL

a.
D027961E08
1.813,1.24 2.302,1.24 true 2.344,1.156 2.688,1.354 0.344,0.198 10 false SST

Using SST and a hammer, tap in a new oil seal.

SST
09350-30020  (09351-32140)

HINT:

Make sure the oil seal end is flush with the outer edge of the pump body.



b.

Coat the lip of the oil seal with MP grease.


Hide 35301 2.FIX FRONT OIL PUMP BODY SUB-ASSEMBLY

a.

Place the oil pump body on the torque converter clutch.


Hide 35322 3.INSTALL FRONT OIL PUMP DRIVEN GEAR

a.
D027959

Coat the driven gear with ATF.


b.

Install the driven gear to the oil pump body.


Hide 35321 4.INSTALL FRONT OIL PUMP DRIVE GEAR

a.
D027958

Coat the drive gear with ATF.


b.

Install the drive gear to the oil pump body.


Hide 35301B 5.INSTALL FRONT OIL PUMP BODY O-RING

a.
D027963E04
1.885,0.365 1.438,0.167 false 1.25,0.052 1.417,0.219 0.167,0.167 10 false *1

Coat a new O-ring with ATF and install it to the oil pump body.

Text in Illustration
*1 New O-Ring


Hide 35370 6.INSTALL STATOR SHAFT ASSEMBLY

a.
D027953

Align the bolt holes of the stator shaft with the bolt holes of the oil pump body and install the stator shaft to the oil pump body.


b.

Install the 14 bolts.

Torque:
11 N*m (110 kgf*cm, 8 ft.*lbf)


Hide 35617 7.INSTALL CLUTCH DRUM OIL SEAL RING

a.
D027952E10
2.052,0.167 2.354,0.469 0.302,0.302 10 false x 3

Coat 3 new oil seal rings with ATF.


b.

Squeeze the ends of the 3 oil seal rings together with an overlap distance of 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

HINT:

After installing the oil seal rings, check that they rotate smoothly.


NOTICE:

Do not excessively widen the rings.



Hide 35111Y 9.INSTALL AUTOMATIC TRANSMISSION CASE O-RING

a.
D027950E05
0.844,0.583 0.75,0.146 0.75,0.146 0.865,0.146 false 0.927,0.052 1.125,0.281 0.198,0.229 10 false *1

Coat a new O-ring with ATF and install it to the oil pump assembly.

Text in Illustration
*1 New O-Ring