Home › Drivetrain › A750E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM
RM1440E _52 Drivetrain _056133 A750E AUTOMATIC TRANSMISSION / TRANSAXLE _0273938 AUTOMATIC TRANSMISSION SYSTEM D

A750E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  CHECK MODE PROCEDURE  


DESCRIPTION


a.

Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are stored with 1 trip detection logic.



CHECK MODE PROCEDURE


a.

Make sure that the following conditions are met:

i.

Battery positive voltage 11 V or higher.


ii.

Throttle valve fully closed.


iii.

Shift lever in P or N.


iv.

A/C off.



b.

Connect the intelligent tester to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the intelligent tester on.


e.

Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.


f.
C140840E02
0.333,0.719 0.604,0.917 0.271,0.198 10 false ON 0.323,1.51 0.677,1.708 0.354,0.198 10 false OFF 2,0.448 3.01,0.646 1.01,0.198 10 false 0.13 sec. 1.906,1.771 2.802,1.969 0.896,0.198 10 false 0.13 sec.

Check that the MIL flashes as shown in the illustration.

NOTICE:
·

All DTCs and freeze frame data will be cleared if: 1) the intelligent tester is used to change the ECM from normal mode to check mode or vice versa; or 2) during check mode, the ignition switch is turned from ON to ACC or off.

·

Before changing to check mode, make notes of the DTCs and freeze frame data.




g.

Start the engine. The MIL should turn off after the engine starts.


h.

Perform "Monitor Drive Pattern" for the ECT test (See page Drivetrain>A750E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>MONITOR DRIVE PATTERN), or simulate the conditions of the malfunction described by the customer.


i.

After simulating the malfunction conditions, use the tester to check the DTCs and freeze frame data.