Home › Drivetrain › A750F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM
RM1440E _52 Drivetrain _056134 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0273939 AUTOMATIC TRANSMISSION SYSTEM J

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  L4 Position Switch Circuit  


DESCRIPTION

The four wheel drive control ECU judges whether the transfer is in the L4 position based on the information from the limit switch inside the transfer shift actuator assembly which is detected by the ECM.

The four wheel drive control ECU then inputs a signal to the combination meter assembly via CAN communication and turns on the 4LO indicator.

WIRING DIAGRAM

C214970E05
1.051,2.106 3.057,2.302 2.007,0.196 10 Four Wheel Drive Control ECU 1.051,1.925 1.443,2.121 0.392,0.196 10 F47 2.495,1.303 2.887,1.498 0.392,0.196 10 21 2.18,1.197 2.572,1.393 0.392,0.196 10 L4 5.636,1.197 6.138,1.393 0.502,0.196 10 L4 5.326,1.303 5.562,1.498 0.236,0.196 10 16 5.809,2.904 6.311,3.100 0.502,0.196 10 F51 5.809,3.083 6.311,3.279 0.502,0.196 10 ECM

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND)
a.
U180828E02
0.385,1.719 0.531,1.281 false 0.052,0.063 0.365,0.26 0.313,0.198 10 false *a 1.594,0.25 1.969,0.479 0.375,0.229 10 false F47 0.26,1.75 0.51,1.948 0.25,0.198 10 false L4

Disconnect the F47 four wheel drive control ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F47-21 (L4) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Front view of wire harness connector
(to Four Wheel Drive Control ECU)



OK

NG

2.CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - ECM)
2.CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - ECM)
a.
U180905E02
0.24,2.771 0.5,2.104 false 0.052,0.042 0.302,0.24 0.25,0.198 10 false *a 0.427,0.406 0.802,0.635 0.375,0.229 10 false F51 0.042,2.802 0.552,3 0.51,0.198 10 false 16 (L4)

Disconnect the F51 ECM connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F51-16 (L4) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Rear view of wire harness connector
(to ECM)



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR