Home › Drivetrain › A750F AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM1440E _52 Drivetrain _056134 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0273943 PARK / NEUTRAL POSITION SWITCH A

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Install the switch to the manual valve shaft.


b.

Temporarily install the bolt.


c.
C155871E03
1.917,1.292 2.063,0.25 2.063,0.25 1.906,0.25 true 1.667,0.156 1.917,0.323 0.25,0.167 10 true *1

Install a new lock washer and the nut.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)

Text in Illustration
*1 New Lock Washer


d.
C212493E02
2.885,0.823 3.031,0.979 0.146,0.156 10 true P 2.49,0.198 2.667,0.354 0.177,0.156 10 true R 1.427,0.094 1.573,0.25 0.146,0.156 10 true N

Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.


e.
U116379E02
1.958,1.594 0.698,1.229 false 1.969,0.927 1.74,0.115 1.74,0.115 1.917,0.115 false 2.906,0.479 2.865,0.531 false 2.771,0.594 2.76,0.615 false 2.885,0.427 2.813,0.542 false 2.833,0.438 2.719,0.594 false 2.771,0.448 2.677,0.583 false 2.74,0.417 2.646,0.573 false 2.708,0.396 2.604,0.552 false 2.583,0.5 2.563,0.542 false 1.938,0.021 2.125,0.188 0.188,0.167 10 false *1 0.479,1.135 0.656,1.313 0.177,0.177 10 false *2

Align the groove with the neutral basic line.

Text in Illustration
*1 Neutral Basic Line
*2 Groove


f.

Hold the switch in position and tighten the bolt.

Torque:
13 N*m (130 kgf*cm, 10 ft.*lbf)


g.

Using a screwdriver, bend the tabs of the lock washer.


h.

Connect the switch connector.