Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE(for 2WD)
RM1440E _52 Drivetrain _056137 AXLE AND DIFFERENTIAL _0273969 STEERING KNUCKLE(for 2WD) A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE(for 2WD)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 43502C 3.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH

a.

Hide 45047 4.DISCONNECT TIE ROD END SUB-ASSEMBLY LH

Hide 48626 5.DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH

F042737

a.

Remove the 2 bolts and disconnect the front lower ball joint attachment from the axle.


Hide 43212 6.REMOVE STEERING KNUCKLE LH

a.

Support the front suspension lower arm LH with a jack.


b.

Remove the clip and nut.


c.
F042736E08
1.927,0.781 2.719,0.188 true 2.76,0.083 3.135,0.281 0.375,0.198 10 false SST

Using SST, disconnect the upper ball joint from the steering knuckle.

SST
09628-62011  

NOTICE:

Do not the damage the ball joint dust cover.



d.

Remove the steering knuckle.