Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0273995 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

The procedure listed below is for the LH side.

·

Other than areas where instructions are provided, use the same procedures for the RH side and LH sides.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 89516 2.REMOVE FRONT SKID CONTROL SENSOR WIRE

a.
C212840

Disconnect the connector from the front speed sensor.


b.

Remove the 2 bolts and 2 harness clamps.


c.

Detach the clip.


d.
C212841

Remove the 2 bolts and 2 harness clamps.


e.

Disconnect the connector as follows.

C212843E01
0.034,0.018 0.245,0.215 0.211,0.198 12 *A 3.648,0.016 3.873,0.213 0.224,0.198 12 *B

Text in Illustration
*A for LH *B for RH

i.

for LH:

1.

Disconnect the connector.

2.

Detach the connector.



ii.

for RH:

1.

Disconnect the connector.

2.

Detach the connector from the skid control sensor clamp.

3.

Detach the clip.

4.

Remove the bolt and skid control sensor clamp.




Hide 3.REMOVE SKID CONTROL SENSOR CLAMP

a.
C212842E01
0.046,0.01 0.302,0.204 0.256,0.194 12 *A 0.055,2.27 0.286,2.465 0.232,0.194 12 *B

Remove the bolt and skid control sensor clamp from the knuckle.

Text in Illustration
*A for LH
*B for RH


Hide 89543 4.REMOVE FRONT SPEED SENSOR

a.

Using a 5 mm hexagon wrench, remove the bolt and speed sensor from the knuckle.

NOTICE:

Pull out the sensor while trying as much as possible not to rotate it.