Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
52129B
2.REMOVE LOWER FRONT BUMPER COVER
Remove the clip, 5 bolts and front bumper cover lower.
51405A
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
4.REMOVE FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY
48810
5.DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH
Remove the nut and disconnect the stabilizer link from the steering knuckle.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
48820B
6.DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH
Use the same procedure described for the LH side.
48829A
7.REMOVE FRONT NO. 1 STABILIZER BRACKET LH
48824A
8.REMOVE FRONT NO. 1 STABILIZER BRACKET RH
48811
9.REMOVE FRONT STABILIZER BAR
10.REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING
Remove the bolt, nut and washer.
Remove the 3 nuts on the top of the front shock absorber with coil spring.
Remove the front shock absorber with coil spring.