Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM1440E _53 Suspension _056140 REAR SUSPENSION _0273989 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 48790 1.TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH

a.

Temporarily install the upper control arm assembly and washer with the nut and bolt.


b.

Temporarily install the upper control arm assembly and washer to the rear axle housing with the nut and bolt.


Hide 2.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 48790 4.TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH

a.
C361887

Tighten the 2 nuts.

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)

HINT:

Turn the nut while holding the bolt.