Home › Suspension › REAR SUSPENSION › REAR LOWER ARM
RM1440E _53 Suspension _056140 REAR SUSPENSION _0273990 REAR LOWER ARM A

REAR SUSPENSION  REAR LOWER ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 48730 1.TEMPORARILY INSTALL LOWER CONTROL ARM ASSEMBLY LH

a.
D028251E07
1.406,1.771 1.646,1.938 0.24,0.167 10 false *a 2.313,1.448 2.531,1.625 0.219,0.177 10 false *b

Temporarily install the lower control arm assembly with the bolt and nut.

Text in Illustration
*a Front
*b Outer Side

HINT:

Install the lower control arm assembly as shown in the illustration.



b.

Temporarily install the lower control arm assembly to the rear axle housing with the nut and bolt.


Hide 46430 2.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.

Connect the No. 3 parking brake cable assembly with the bolt.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


Hide 3.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 48730 5.TIGHTEN LOWER CONTROL ARM ASSEMBLY LH

a.
C361888

Tighten the 2 bolts.

Torque:
130 N*m (1326 kgf*cm, 96 ft.*lbf)

HINT:

While holding the nut, turn the bolt.