Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM
RM1440E _53 Suspension _056141 TIRE / WHEEL _0273994 TIRE AND WHEEL SYSTEM G

TIRE / WHEEL  TIRE AND WHEEL SYSTEM  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIRES

a.

Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure (Unloaded Vehicle):
Tire Size Front
kpa (kgf/cm2, psi)
Rear
kpa (kgf/cm2, psi)
245/70R17 110S 200 (2.0, 29) 200 (2.0, 29)
265/60R18 110H 200 (2.0, 29) 200 (2.0, 29)



b.
C137874

Using a dial indicator, check the tire runout.

Standard tire runout:

3.0 mm (0.118 in.) or less



Hide 2.ROTATE TIRES

C217324

HINT:

Rotate the tires as shown in the illustration.


Text in Illustration
V100135

Front

Hide 3.INSPECT WHEEL BALANCE

a.
C361897E01
1.427,0.615 1.74,0.813 0.313,0.198 10 false *a 0.656,1.427 0.969,1.625 0.313,0.198 10 false (A) 1.979,1.563 2.292,1.76 0.313,0.198 10 false (A) 2.063,3.885 2.375,4.083 0.313,0.198 10 false (A) 1.417,2.948 1.729,3.146 0.313,0.198 10 false *b

Check and adjust the off-the-car balance.

Text in Illustration
*a 265/60R18 110H
*b 245/70R17 110S


b.

If necessary, check and adjust the on-the-car balance.

Standard imbalance after adjustment:

6.0 g (0.0132 lb) or less


NOTICE:
·

Using a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

·

Do not touch the adhesive surface of the tape.

·

Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)


·

Push the balance weight securely with your finger to adhere it to the position.

·

Do not reuse the balance weight.




Hide 4.INSPECT FRONT AXLE HUB

a.

b.

Hide 5.INSPECT REAR AXLE SHAFT

a.

Inspect the rear axle shaft (See page Drivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT>INSPECTION).