Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB(for 4WD)
RM1440E _52 Drivetrain _056137 AXLE AND DIFFERENTIAL _0273968 FRONT AXLE HUB(for 4WD) G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB(for 4WD)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 47750 2.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

Hide 43512 3.REMOVE FRONT DISC

Hide 43514C 4.REMOVE FRONT AXLE HUB GREASE CAP

Hide 5.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C214991

Using a dial indicator, measure the looseness near the center of the axle hub.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:

Make sure that the dial indicator is set at a right angle to the measurement surface.


If the looseness is more than the maximum, replace the axle hub.


Hide 6.INSPECT FRONT AXLE HUB RUNOUT

a.
C214992

Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolts.

Maximum runout:

0.08 mm (0.00315 in.)


NOTICE:

Make sure that the dial indicator is set at a right angle to the measurement surface.


If the runout is more than the maximum, replace the axle hub.


Hide 47750 9.INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

Hide 10.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)