BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS
VEHICLE STABILITY CONTROL SYSTEM
- PRECAUTION
- PARTS LOCATION2009.08–2010.082010.08–2013.08from 2013.08
- SYSTEM DIAGRAM2009.08–2010.082010.08–2013.08from 2013.08
- SYSTEM DESCRIPTION2009.08–2010.082010.08–2013.08from 2013.08
- HOW TO PROCEED WITH TROUBLESHOOTING
- CHECK FOR INTERMITTENT PROBLEMS
- CALIBRATION
- TEST MODE PROCEDURE2009.08–2010.08from 2010.08
- PROBLEM SYMPTOMS TABLE2009.08–2010.082010.08–2013.08from 2013.08
- TERMINALS OF ECU2009.08–2010.082010.08–2013.08from 2013.08
- DIAGNOSIS SYSTEM2009.08–2010.08from 2010.08
- DTC CHECK / CLEAR2009.08–2010.082010.08–2013.08from 2013.08
- FREEZE FRAME DATA2009.08–2010.082010.08–2013.08from 2013.08
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST2009.08–2010.082010.08–2013.08from 2013.08
- DIAGNOSTIC TROUBLE CODE CHART2009.08–2010.082010.08–2013.08from 2013.08
- 432009.08–2010.08from 2010.08
- C0226, C0236, C0246, C0256, C1225, C1226, C1227, C12282009.08–2010.08from 2010.08
- C0278, C02792009.08–2010.08from 2010.08
- C1201 A malfunction signal is received from the ECM.
- C1203 The engine/drivetrain specification and/or destination information from the ECM does not match the skid...
- C120A The master cylinder solenoid is not informed that the vehicle is equipped with downhill assist control and...2009.08–2010.08from 2010.08
- C1210, C13362009.08–2010.08from 2010.08
- C0371, C1232, C1243, C1245, C1279 2009.08–2010.08
- C1240 The yaw rate and acceleration sensor identification information memorized by the skid control ECU does not...2009.08–2010.08from 2010.08
- C1241 Either condition is met: 1. Both of the following conditions continue for at least 10 seconds. · The vehicle...2009.08–2010.08from 2010.08
- C1242 The vehicle speed is 3 km/h (2 mph) or more and the voltage at the ECU IG2 terminal remains below 6.5 V for...2009.08–2010.08from 2010.08
- C1251 There is an open in the motor system circuit (motor input circuit).2009.08–2010.08from 2010.08
- C1252 The motor operates for 3 minutes or more.2009.08–2010.08from 2010.08
- C1253 There is a motor system circuit (motor input circuit) malfunction.2009.08–2010.08from 2010.08
- C1254 There is an accumulator pressure sensor malfunction (the fluid pressure does not change when the pump...2009.08–2010.08from 2010.08
- C1256 The fluid pressure inside the accumulator is below the standard value.2009.08–2010.08from 2010.08
- C1257 There is an open in the motor system circuit (motor input circuit).2009.08–2010.08from 2010.08
- C1268, C12832009.08–2010.08from 2010.08
- C1282 Stored during test mode.2009.08–2010.08from 2010.08
- C1290 The steering angle sensor zero point calibration position vastly differs from the recorded value.
- C1337 Either condition is met: · The diameter of 2 front wheels and 2 rear wheels is different. · There is a wheel...2009.08–2010.08from 2010.08
- C1340 An open circuit is detected in the EXI circuit of the skid control ECU.2009.08–2010.08from 2010.08
- C1379 Stored only during test mode.2009.08–2010.08from 2010.08
- C1380 · When the voltage at the IG1 terminal is 9.5 V or more and the stop light control relay drive output (STPO)...2009.08–2010.082010.08–2013.08from 2013.08
- C1381 At a vehicle speed of more than 3 km/h (2 mph), the acceleration sensor power source malfunction signal is...2009.08–2010.08from 2010.08
- C1271, C1272, C1401, C14022009.08–2010.08from 2010.08
- C1273, C1274, C1403, C14042009.08–2010.08from 2010.08
- C1405, C14062009.08–2010.08from 2010.08
- C1407, C14082009.08–2010.08from 2010.08
- C1409, C14102009.08–2010.08from 2010.08
- C1411, C14122009.08–2010.08from 2010.08
- C1275, C1276, C1413, C14142009.08–2010.08from 2010.08
- C1277, C1278, C1415, C14162009.08–2010.08from 2010.08
- C1417 The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more.2009.08–2010.08from 2010.08
- C1419, C14352009.08–2010.08from 2010.08
- C1420 After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference...2009.08–2010.08from 2010.08
- C1281, C1421, C1423, C1424, C1455, C1457, C1458
- C1422, C14562009.08–2010.08from 2010.08
- C1425 When the IG1 terminal voltage is between 9.5 and 17.4 V and the skid control ECU STPO terminal output is off,...2009.08–2010.08from 2010.08
- C1432 A steering angle sensor power supply malfunction signal is received from the steering angle sensor.
- C1433 Either condition is met: 1. With the IG1 terminal voltage at 9.5 to 17.4 V, the skid control ECU receives an...2009.08–2010.08from 2010.08
- C1434 An error in communication between the skid control ECU and the steering angle sensor, or an abnormal steering...2009.08–2010.08from 2010.08
- C1436 Either condition is met: 1. With the vehicle stationary, the yaw rate and acceleration sensor output value is...2009.08–2010.08from 2010.08
- C1437 When the IG1 terminal voltage is 10 V or higher and the vehicle speed is 15 km/h (9 mph) or more, data cannot...2009.08–2010.08from 2010.08
- C1439, C14452009.08–2010.08from 2010.08
- C1440 Driving at a steep bank angle2009.08–2010.08from 2010.08
- C1442, C14432009.08–2010.08from 2010.08
- C1452 After braking, the fluid pressure inside the accumulator is below the threshold within 3.2 seconds.2009.08–2010.08from 2010.08
- C1453, C14542009.08–2010.08from 2010.08
- U0073, U0100, U0114, U0123, U0124, U01262009.08–2010.08from 2010.08
- C1232, C1243, C1245, C1279 from 2010.08
- ABS Warning Light Remains ON2009.08–2010.08from 2010.08
- ABS Warning Light does not Come ON2009.08–2010.08from 2010.08
- Brake Warning Light Remains ON2009.08–2010.08from 2010.08
- Brake Warning Light does not Come ON2009.08–2010.08from 2010.08
- TRC OFF Indicator Light Remains ON2009.08–2010.08from 2010.08
- TRC OFF Indicator Light does not Come ON2009.08–2010.08from 2010.08
- VSC OFF Indicator Light Remains ON2009.08–2010.08from 2010.08
- VSC OFF Indicator Light does not Come ON2009.08–2010.08from 2010.08
- Slip Indicator Light Remains ON2009.08–2010.082010.08–2013.08from 2013.08
- Slip Indicator Light does not Come ON2009.08–2010.08from 2010.08
- Downhill Assist Control Indicator Light Remains ON2009.08–2010.08from 2010.08
- Downhill Assist Control Indicator Light does not Come ON2009.08–2010.08from 2010.08
- AUTO LSD Indicator Light Remains ON2009.08–2010.08from 2010.08
- AUTO LSD Indicator Light does not Come ON2009.08–2010.08from 2010.08
- A-TRAC Indicator Light Remains ON2009.08–2010.08from 2010.08
- A-TRAC Indicator Light does not Come ON2009.08–2010.08from 2010.08
- Skid Control Buzzer Circuit 2009.08–2010.08
- TC and CG Terminal Circuit2009.08–2010.08from 2010.08
- TS and CG Terminal Circuit
- Preparation
FRONT SPEED SENSOR
REAR SPEED SENSOR
YAW RATE AND ACCELERATION SENSOR
STEERING ANGLE SENSOR
SKID CONTROL BUZZER
TRACTION OFF SWITCH
VSC OFF SWITCH
DOWNHILL ASSIST CONTROL SWITCH
RELAY