Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › RELAY
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0274003 RELAY G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK STOP LIGHT CONTROL RELAY

a.

Remove the stop light control relay from the engine room relay block.


b.
A087121E46
2.333,0.615 2.333,0.302 false 2.479,1.135 2.948,1.135 false 2.479,1.635 2.948,1.635 false 2.031,0.625 1.854,0.313 false 2.615,0.625 2.792,0.313 false 0.323,1.417 0.521,1.625 0.198,0.208 10 false 1 1.771,0.115 1.969,0.323 0.198,0.208 10 false 1 1.313,1.427 1.51,1.635 0.198,0.208 10 false 2 2.781,0.115 2.979,0.323 0.198,0.208 10 false 2 0.323,0.875 0.521,1.083 0.198,0.208 10 false 3 3,1.552 3.198,1.76 0.198,0.208 10 false 3 0.948,0.417 1.146,0.625 0.198,0.208 10 false 4 2.292,0.104 2.49,0.313 0.198,0.208 10 false 4 1.313,0.885 1.51,1.094 0.198,0.208 10 false 5 3.01,1.042 3.208,1.25 0.198,0.208 10 false 5

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2 Below 1 Ω
Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage to terminal 2 10 kΩ or higher
3 - 5 Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2 10 kΩ or higher
Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage to terminal 2 Below 1 Ω


If the result is not as specified, replace the relay.


c.

Install the stop light control relay.