Home › Brake › BRAKE SYSTEM (OTHER) › HYDRAULIC BRAKE BOOSTER
RM1440E _54 Brake _056143 BRAKE SYSTEM (OTHER) _0274008 HYDRAULIC BRAKE BOOSTER A

BRAKE SYSTEM (OTHER)  HYDRAULIC BRAKE BOOSTER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

When pressure in the power supply system is released, the reaction force decrease and the stroke becomes longer.


NOTICE:
·

Be sure not to allow the pump to contact the floor; support it with the booster body. If the pump contacts the floor, the red brake tube between the pump and booster body may be deformed, the operating sound of the pump may become loud enough to hear within the cabin, and fluid may leak.

·

When installing, coat the parts indicated by arrows with lithium soap base glycol grease (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER>COMPONENTS).

·

As high pressure is applied to the brake actuator tube No. 1, never deform it.

·

Do not turn the ignition switch ON until the procedures are completed.

·

Before starting the work, make sure that the engine switch is off and depress the brake pedal more than 20 times.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes into contact with a painted surface.


Hide 55045 3.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

a.

Remove the lower instrument panel finish panel sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL).


Hide 47264A 4.REMOVE PUSH ROD PIN

a.

Remove the clip and push rod pin from the brake pedal lever.


Hide 5.REMOVE HYDRAULIC BRAKE BOOSTER ASSEMBLY

a.
C215277

Disconnect the 3 connectors from the hydraulic brake booster assembly.


b.
C361956E01
0.719,0.76 1.177,0.76 1.177,0.76 1.177,1.198 false 1.281,0.146 1.573,0.146 1.573,0.146 1.573,1.531 true 2.448,0.24 2.313,0.24 2.313,0.24 2.021,1.74 true 2.854,0.771 2.677,0.771 2.677,0.771 2.479,1.823 true 0.469,0.667 0.708,0.854 0.24,0.188 10 false *3 1.073,0.073 1.313,0.26 0.24,0.188 10 false *1 2.5,0.167 2.74,0.354 0.24,0.188 10 false *2 2.927,0.698 3.167,0.885 0.24,0.188 10 false *4

Use tags or make a memo to identify the place to reconnect.

HINT:
·

*1: To front wheel cylinder RH

·

*2: To front wheel cylinder LH

·

*3: To rear wheel cylinder RH

·

*4: To rear wheel cylinder LH




c.
C217148

Using a union nut wrench, disconnect the 4 brake lines from the hydraulic brake booster assembly.


d.
C214646

Remove the 4 nuts and pull out the hydraulic brake booster assembly.


Hide 44785C 6.REMOVE BRAKE BOOSTER GASKET

a.

Remove the brake booster gasket from the hydraulic brake booster assembly.