Home › Brake › BRAKE (FRONT) › FRONT BRAKE › from 2015.08
RM1440E _54 Brake _056144 BRAKE (FRONT) _0274011 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43512 1.INSTALL FRONT DISC

a.

Align the matchmarks and install the front disc.

HINT:

When replacing the disc with a new one, select the installation position where the disc has the smallest runout.



Hide 47750 2.INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

a.

Install the disc brake cylinder assembly with the 2 bolts.

Torque:
185 N*m (1887 kgf*cm, 137 ft.*lbf)


b.

Using a union nut wrench, connect the brake tube to the disc brake cylinder assembly.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 04465 3.INSTALL FRONT DISC BRAKE PAD

a.

Install the front No. 1 anti-squeal shims to the front disc brake pads.

NOTICE:

There should be no oil or grease on the friction surfaces of the brake pads and the front disc.



b.

Install the 2 front disc brake pads to the disc brake cylinder.


c.

Install the front disc brake anti-rattle spring between the 2 pads.

NOTICE:

The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign matter cleaned off.



d.

Install the 2 hole pins.


e.

Install the pin hold clip.

NOTICE:

The pin hold clip can be reused if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign matter cleaned off.