Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE
RM1440E _54 Brake _056145 BRAKE (REAR) _0274012 REAR BRAKE FLEXIBLE HOSE A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 47355A 1.INSTALL NO. 5 FLEXIBLE HOSE BRACKET

a.

Install the bracket with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)

NOTICE:

Make sure the bracket rotation stopper touches the installation position.



Hide 47356 2.INSTALL NO. 6 FLEXIBLE HOSE BRACKET

a.

Install the bracket with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)

NOTICE:

Make sure the bracket rotation stopper touches the installation position.



Hide 47319F 3.INSTALL REAR FLEXIBLE HOSE

a.

Connect the rear flexible hose to the connecting point with each brake tube, and then install 2 new clips.


b.

Using a union nut wrench, connect each brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




c.

Connect the flexible hose to the connecting point with each brake tube, and then install 2 new clips.


d.

Using a union nut wrench, connect each brake tube to the flexible hose while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




Hide 47319F 4.INSTALL REAR FLEXIBLE HOSE LH

a.

Connect the rear flexible hose to the connecting point with the brake tube, and then install a new clip.


b.

Using a union nut wrench, connect the brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




c.

Install the rear flexible hose and a new gasket to the rear disc brake cylinder with the union bolt.

Torque:
31 N*m (316 kgf*cm, 23 ft.*lbf)

HINT:

Install the rear flexible hose lock securely to the lock hole in the cylinder.