Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH
RM1440E _54 Brake _056146 PARKING BRAKE _0274018 PARKING BRAKE SWITCH A

PARKING BRAKE  PARKING BRAKE SWITCH  INSTALLATION  


PROCEDURE

Hide 84550 1.INSTALL PARKING BRAKE SWITCH ASSEMBLY

a.

Install the parking brake switch assembly to the parking brake control pedal assembly with the screw.

Torque:
3.2 N*m (33 kgf*cm, 28 in.*lbf)


Hide 46200 2.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

a.

Temporarily install the parking brake control pedal assembly with the 3 nuts.


b.

Tighten the 3 nuts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


c.

Connect the parking brake switch connector.


d.

Install the No. 1 parking brake cable assembly to the body with the 2 nuts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


Hide 55045 4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

a.

Install the lower instrument panel finish panel sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).


Hide 5.INSTALL CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).