Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH
RM1440E _54 Brake _056146 PARKING BRAKE _0274018 PARKING BRAKE SWITCH A

PARKING BRAKE  PARKING BRAKE SWITCH  REMOVAL  


PROCEDURE

Hide 1.REMOVE CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55045 2.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

a.

Remove the lower instrument panel finish panel sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL).


Hide 81980 3.REMOVE TURN SIGNAL FLASHER ASSEMBLY

Hide 46200 4.DISCONNECT PARKING BRAKE CONTROL PEDAL ASSEMBLY

a.

Partially remove the front floor carpet


b.
C215933

Remove the 2 nuts and disconnect the No. 1 parking brake cable assembly from the body.


c.

Disconnect the parking brake switch connector.


d.
C361683

Remove the 3 nuts and disconnect the parking brake control pedal assembly from the body.


Hide 84550 5.REMOVE PARKING BRAKE SWITCH ASSEMBLY

a.
C215300

Remove the screw and parking brake switch assembly from the parking brake control pedal assembly.