Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2009.08–2013.08
RM1440E _55 Steering _056147 POWER ASSIST SYSTEMS _0274019 POWER STEERING SYSTEM S

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


HINT:

If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.


Power Steering System
DTC Code Detection Item Trouble Area Return-to-normal See page
C1231 Lost Communication with Steering Angle Sensor Module - Steering angle sensor (Spiral cable sub-assembly)
- CAN communication system
- Power steering ECU assembly
After normal confirmation (Click here)
C1531 ECU Malfunction - Harness or connector
- Vane pump assembly
- Power steering ECU assembly
Ignition switch turned to ON again (Click here)
C1544 High Engine Revolution Signal - Engine control system
- CAN communication system
- Power steering ECU assembly
After normal confirmation (Click here)
C1547 Vehicle Speed Sensor - Speed sensor circuit
- Brake control system
- CAN communication system
- Power steering ECU assembly
After normal confirmation (Click here)
U0073 Control Module Communication Bus Off CAN communication system After CAN communication system returns to normal condition or ignition switch
turned to ON again
(Click here)