Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2009.08–2013.08
RM1440E _55 Steering _056147 POWER ASSIST SYSTEMS _0274019 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1231  Lost Communication with Steering Angle Sensor Module  


DESCRIPTION

The power steering ECU receives steering angle signals from the steering angle sensor via CAN communication. The power steering ECU provides appropriate assisting force in accordance with the steering angle signal.

DTC Code DTC Detection Condition Trouble Area
C1231 An abnormal steering angle signal is received.
·

Steering angle sensor (Spiral cable sub-assembly)

·

CAN communication system

·

Power steering ECU assembly



PROCEDURE

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
a.

Check if DTC U0073 is output (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC U0073 is not output. A
DTC U0073 is output. B

HINT:

DTC U0073 indicates a CAN communication malfunction in the power steering system.




A

2.CHECK OTHER DTC OUTPUT (BRAKE CONTROL SYSTEM)

B

REPAIR CIRCUIT INDICATED BY OUTPUTCODE

2.CHECK OTHER DTC OUTPUT (BRAKE CONTROL SYSTEM)
a.

Using the intelligent tester, check for DTCs related to the steering angle sensor and confirm that there are no problems in the brake control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output. A
DTC is output. B



A

REPLACE POWER STEERING ECU ASSEMBLY

B

GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)