Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2009.08–2013.08
RM1440E _55 Steering _056147 POWER ASSIST SYSTEMS _0274019 POWER STEERING SYSTEM D

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  DTC CHECK / CLEAR  


CHECK DTC


a.

Turn the ignition switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the intelligent tester on.


e.

Enter the following menus: Chassis / PPS / DTC.


f.

Read the DTCs following the display on the intelligent tester.


g.

Refer to Diagnostic Trouble Code Chart for DTC information (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).



CLEAR DTC


a.

Turn the ignition switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the intelligent tester on.


e.

Enter the following menus: Chassis / PPS / DTC.


f.

Clear the DTCs by following the display on the intelligent tester.


g.

Turn the ignition switch off.


h.

Disconnect the intelligent tester from the DLC3.