Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2013.08
RM1440E _55 Steering _056147 POWER ASSIST SYSTEMS _0274019 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1544  High Engine Revolution Signal  


DESCRIPTION

The power steering ECU receives engine speed signals from the ECM via CAN communication. The power steering ECU provides appropriate assisting force in accordance with the engine speed signal.

DTC Code DTC Detection Condition Trouble Area
C1544 An abnormal engine speed signal is received.
·

SFI system

·

CAN communication system

·

Power steering ECU assembly



PROCEDURE

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
a.

Check if DTC U0100 is output (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC U0100 is not output. A
DTC U0100 is output. B

HINT:

DTC U0100 indicates a CAN communication malfunction in the power steering system.




A

2.CHECK OTHER DTC OUTPUT (ENGINE CONTROL SYSTEM)

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK OTHER DTC OUTPUT (ENGINE CONTROL SYSTEM)
a.

Using the intelligent tester, check for DTCs and confirm that there are no problems in the SFI system (See page Engine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output. A
DTC is output. B



A

REPLACE POWER STEERING ECU ASSEMBLY

B

GO TO SFI SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)