Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU
RM1440E _55 Steering _056147 POWER ASSIST SYSTEMS _0274021 POWER STEERING ECU A

POWER ASSIST SYSTEMS  POWER STEERING ECU  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55475A 4.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55607 5.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55443A 7.REMOVE INSTRUMENT PANEL BOX DOOR COVER

Hide 55303B 8.REMOVE INSTRUMENT LOWER PANEL SUB-ASSEMBLY

Hide 89650 11.REMOVE POWER STEERING ECU ASSEMBLY

a.
C215460

Using a screwdriver, detach the 2 claws and remove the power steering ECU assembly.

HINT:

Tape the screwdriver tip before use.