Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2013.08
RM1440E _55 Steering _056147 POWER ASSIST SYSTEMS _0274019 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C15F1  Steering Angle Sensor Circuit  


DESCRIPTION

The power steering ECU assembly receives steering angle signals from the steering angle sensor via CAN communication. The power steering ECU assembly provides appropriate assisting force in accordance with the steering angle signal.

DTC Code DTC Detection Condition Trouble Area
C15F1 An abnormal steering angle signal is received.
·

Steering angle sensor

·

CAN communication system

·

Power steering ECU assembly



PROCEDURE

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
a.

Check if DTC U0126 is output (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC U0126 is not output. A
DTC U0126 is output. B

HINT:

DTC U0126 indicates a CAN communication malfunction in the power steering system.




A

2.CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)
a.

Using the intelligent tester, check for DTCs related to the steering angle sensor and confirm that there are no problems in the vehicle stability control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output. A
DTC is output. B



A

REPLACE POWER STEERING ECU ASSEMBLY

B

GO TO VEHICLE STABILITY CONTROL SYSTEM (DAIAGNOSTIC TROUBLE CODE CHART)