Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2013.08
RM1440E _55 Steering _056147 POWER ASSIST SYSTEMS _0274019 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1541  Vehicle Speed Signal  


DESCRIPTION

The power steering ECU assembly receives vehicle speed signals from the master cylinder solenoid (skid control ECU) via CAN communication. The power steering ECU assembly provides appropriate assisting force in accordance with the vehicle speed signal.

DTC Code DTC Detection Condition Trouble Area
C1541 An abnormal vehicle speed signal is received.
·

Speed sensor circuit

·

Vehicle stability control system

·

CAN communication system

·

power steering ECU assembly



PROCEDURE

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
a.

Check if DTC U0129 is output (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC U0129 is not output. A
DTC U0129 is output. B

HINT:

DTC U0129 indicates a CAN communication malfunction in the power steering system.




A

2.CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)
a.

Using the intelligent tester, check for DTCs and confirm that there are no problems in the vehicle stability control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output. A
DTC is output. B



A

REPLACE POWER STEERING ECU ASSEMBLY

B

GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)