Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM1440E _55 Steering _056148 STEERING COLUMN _0274023 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 45203 1.CONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

a.

Align the matchmarks on the No. 2 steering intermediate shaft and power steering gear.


b.

Install the bolt.

Torque:
36 N*m (367 kgf*cm, 27 ft.*lbf)


Hide 45026D 2.INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

a.

Install the 4 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)

NOTICE:

Do not fold back the boot part of the steering hole cover or extend it excessively. If it is extended excessively, return it to its original position.



Hide 45220 3.CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

a.

Align the matchmarks on the No. 2 steering intermediate shaft assembly and steering intermediate shaft assembly.

HINT:

Install the steering intermediate shaft from the inside of the vehicle.



b.

Install the bolt.

Torque:
36 N*m (367 kgf*cm, 27 ft.*lbf)


Hide 53737A 4.INSTALL NO. 1 FRONT FENDER APRON TO FRAME SEAL LH

Hide 45250 5.INSTALL STEERING COLUMN ASSEMBLY

a.

Align the matchmarks on the steering intermediate shaft and steering column.


b.

Install the steering column with the 4 nuts.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


c.

Install the bolt.

Torque:
36 N*m (367 kgf*cm, 27 ft.*lbf)


d.

Attach the claws to connect the wire harness.


Hide 89783 6.INSTALL TRANSPONDER KEY AMPLIFIER (w/ Transponder Key)

Hide 7.INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

a.

Using pliers, grip the claws of the clamp and install the combination switch assembly with spiral cable sub-assembly to the steering column assembly with the clamp.


b.

Connect the connectors to the combination switch with spiral cable.


Hide 45286B 8.INSTALL STEERING COLUMN UPPER COVER

a.

Attach the claw to install the steering column upper cover.


b.

Attach the 4 clips to install the steering column upper cover to the instrument cluster finish panel.


Hide 45287 9.INSTALL STEERING COLUMN LOWER COVER

a.

Attach the 2 claws to install the steering column lower cover.


b.

Install the 2 screws.


Hide 45100 10.INSTALL STEERING WHEEL ASSEMBLY

a.

Install the steering wheel assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>INSTALLATION).


Hide 11.CHECK FRONT WHEELS FACING STRAIGHT AHEAD

Hide 12.INSTALL FRONT WHEEL LH

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 14.CHECK SRS WARNING LIGHT