Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM1440E _55 Steering _056148 STEERING COLUMN _0274023 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 2.REMOVE FRONT WHEEL LH

Hide 45100 3.REMOVE STEERING WHEEL ASSEMBLY

a.

Remove the steering wheel (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).


Hide 45287 4.REMOVE STEERING COLUMN LOWER COVER

a.
C216494

Remove the 2 screws.


b.

Detach the 2 claws to remove the steering column lower cover.


Hide 45286B 5.REMOVE STEERING COLUMN UPPER COVER

a.
C216495

Detach the 4 clips.


b.

Detach the claw to remove the steering column upper cover.


Hide 6.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

a.

Disconnect the connectors from the combination switch with spiral cable.


b.
C216496

Use pliers to hold the clamp and raise the claw with a screwdriver. Remove the turn signal switch assembly with spiral cable sub-assembly from the steering column assembly.


Hide 89783 7.REMOVE TRANSPONDER KEY AMPLIFIER (w/ Transponder Key)

Hide 45250 8.REMOVE STEERING COLUMN ASSEMBLY

a.

Detach the claws to remove the wire harness protector and wire harness.


b.
U150202E02
1.875,1.531 2.74,0.333 true 3.01,0.25 3.26,0.448 0.25,0.198 10 false *a

Put matchmarks on the steering intermediate shaft and steering column.

Text in Illustration
*a Matchmark


c.

Remove the bolt.


d.
C216497

Remove the 4 nuts and steering column.


Hide 53737A 9.REMOVE NO. 1 FRONT FENDER APRON TO FRAME SEAL LH

Hide 45220 10.DISCONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

a.
C215850E09
2.208,0.844 2.521,1.698 2.521,1.698 2.917,1.698 true 2.302,0.76 2.781,1.698 true 2.927,1.604 3.292,1.854 0.365,0.25 10 true *a

Put matchmarks on the steering intermediate shaft and No. 2 steering intermediate shaft.

Text in Illustration
*a Matchmark


b.

Remove the bolt, and then pull out the intermediate shaft toward the inside of the vehicle.


Hide 45026D 11.REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

a.
C215852

Remove the 4 bolts and steering column hole cover from the vehicle.


Hide 45203 12.DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

a.
U148518E03
2.104,1.167 1.365,0.323 true 1.052,0.208 1.49,0.521 0.438,0.313 10 false *a

Put matchmarks on the No. 2 steering intermediate shaft and power steering gear.

Text in Illustration
*a Matchmark


b.

Remove the bolt and No. 2 steering intermediate shaft from the power steering gear.