| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| 62-46 | Scratches or dirt is found on the disc surface or the disc is inserted upside down. | ·
Disc ·
Radio receiver assembly |
After the inspection is completed, clear the DTCs.
Check whether or not the disc is inserted upside down.
The disc is properly inserted.
OK
NG
Check that the disc is not deformed or cracked.
No deformation or cracks on the disc.
OK
NG
If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.
Do not use a conventional record cleaner or antistatic preservative.
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs and check if the same trouble occurs again.
Malfunction disappears.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Replace the disc with a normal one.
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check if the same trouble occurs again.
Malfunction disappears.
OK
NG