Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2009.08–2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Mute Signal Circuit between Radio Receiver and Multi-media Interface ECU  


DESCRIPTION

The multi-media interface ECU sends a mute signal to the radio receiver assembly.

The radio receiver assembly controls the volume according to the MUTE signal from the multi-media interface ECU.

The MUTE signal is sent to reduce noise and popping sounds generated when switching modes.

If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.

If there is a short in the circuit, even though the radio receiver assembly is functioning, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM

E175068E35
0.381,2.201 0.759,2.370 0.378,0.170 10 G11 0.369,2.364 2.101,2.547 1.732,0.184 10 Multi-media Interface ECU 5.512,2.352 7.142,2.502 1.630,0.150 10 Radio Receiver Assembly 1.02,1.119 1.467,1.305 0.448,0.185 10 MUT1 5.748,1.136 6.203,1.328 0.455,0.193 10 MUTE 5.502,2.189 5.804,2.358 0.302,0.170 10 G8 5.467,1.001 5.634,1.167 0.166,0.166 10 6 1.55,0.993 1.761,1.142 0.211,0.149 10 6

PROCEDURE

1.CHECK MULTI-MEDIA INTERFACE ECU
a.
E195974E12
1.229,1.208 0.844,1.333 0.844,1.333 0.688,1.333 true 0.052,0.052 0.385,0.271 0.333,0.219 10 false *a 0.229,1.281 0.646,1.5 0.417,0.219 10 false MUT1

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G11-6 (MUT1) - Body ground Ignition switch ACC Above 3.5 V


Text in Illustration
*a Component with harness connected
(Multi-media Interface ECU)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - MULTI-MEDIA INTERFACE ECU)
2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - MULTI-MEDIA INTERFACE ECU)
a.

Disconnect the G8 radio receiver assembly connector.


b.

Disconnect the G11 multi-media interface ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G8-6 (MUTE) - G11-6 (MUT1) Always Below 1 Ω
G8-6 (MUTE) - Body ground Always 10 kΩ or higher




OK

REPLACE RADIO RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR